The new reproduction panels are produced from fiberglass and finished off with a strong gel coating in the color of Toyota black 202. This has produced an exceptional high standard gloss finish.
The panel can be easily repainted to the color of your car however the black look is a great finish on most colors.
The fitting of the panel is the same as the original Autopista panel. The panel comes with fitted double sided 3m tape which is extremely strong.
Simply peel the film from the tape which is attached to the new panel and apply to your existing 91-93 single lined center panel with equal pressure.
It is advisable to remove your existing center panel from the car and wash down and clean any dirt or grease and leave to dry. This will allow for the best attachment of the sticky tape to the panel.
Ensure you place the new panel symmetrically over the new panel and ensure it covers the whole area of the original panel.
This shall allow for the panel to fit correctly and for the trunk to close properly when it is fully installed.
When applying the panel back into the car, make sure all four screws are fully attached from the inside of the trunk using a 8mm socket and that the tail lights have been correctly fitted.
It is always advisable to do a test fit before committing to the full installation.
In the rare event that the panel comes away from the original panel, it is advisable to purchase further double sided tape and apply where needed
The reason for using double sided tape is so that if you decide to take the Autopista panel off then you still have the original which is undamaged.
- This only fits MR2s with 1991-1993 Tail lights/Rear Center panel installed